A system that's short-cycling, tripping breakers, or throwing an error code isn't something to fix by trial and error. We test capacitors, contactors, and refrigerant pressure before recommending a single part, on every White Swan call.
The overwhelming majority of Hvac Repair visits come down to one of a handful of usual suspects: capacitors, contactors, control boards. A proper meter check separates a cheap fix from an unnecessary expensive one, and we'd rather find the $150 answer.
What you're actually getting when you call us.
Every tech carries a current license, EPA 608 refrigerant certification, and liability coverage — no subcontractors ever.
Trucks are staged around White Swan, WA for quick White Swan response, most calls land a same-day or next-morning window instead of a week-long wait.
You approve a fixed price before we touch anything, and that price doesn't move once work begins, agreed to upfront.
Manifold gauges, clamp meters, and combustion analyzers ride on every truck, so the fault gets measured, not assumed.
The repairs behind most of our service calls.
We isolate the fault — capacitor, contactor, thermostat signal, refrigerant charge — before recommending any repair: capacitor, contactor, thermostat call, or charge level.
A failed run capacitor is behind a huge share of no-start calls, and it's confirmed with a microfarad reading, not a guess, and we confirm it with an actual meter reading before replacing anything.
High amp draw or a seized bearing on the blower motor shows up as weak airflow or a burning smell, and we test the windings before recommending replacement.
A miscalibrated thermostat or a glitchy control board can mimic a much bigger failure than it actually is, and we rule these out before quoting anything larger.
We locate the real leak, because a top-off without finding the source only buys a few weeks.
Ignitor resistance, flame sensor microamp signal, and gas valve response all get tested before a furnace gets condemned, since a dirty flame sensor is a five-minute fix, not a new furnace.
What happens once you dial in.
Tell us what's happening and we'll get a tech moving — no phone tree to navigate.
You get a fully equipped truck, on time — not a vague all-day estimate.
Full diagnostic first, flat-rate quote second, your approval before we touch anything.
Most repairs wrap same visit, backed by a written labor warranty, covered by our warranty.
Unedited feedback from our White Swan customers.
Breaker kept popping every time the blower kicked on. Turned out to be a shorted wire nobody had caught in two prior visits from other companies.
— N. Okafor, homeowner
Appreciated getting a text with a two-hour window instead of the usual 'sometime this afternoon.' Tech was right on time.
— V. Delgado, property manager
System was cycling on and off every few minutes. They traced it to a thermostat wiring issue, not the compressor everyone assumed it was.
— L. Whitfield, homeowner
Third HVAC company we've tried for our small office building. First one to actually pull a service history instead of starting from zero each visit.
— C. Abernathy, office manager
Common questions before booking.
Most calls get a same-day or next-morning slot, with a text update once the tech is en route, and dispatch texts you once the tech is moving.
Yes, but it's a known number before anyone shows up, and it comes off the final bill if you go ahead with the repair, and it's subtracted once you approve the fix.
Measurement comes before the quote, so you're never charged for an assumption.
No — the flat-rate quote holds unless new work is discovered and you approve it separately unless something new turns up and you sign off on it.
Yes, our techs are trained and certified on both fuel types equally.
We service whatever's already installed, regardless of who put it in.
Coverage extends through White Swan and the nearby zips listed here.
Confirm My Coverage
